DOC HOME SITE MAP MAN PAGES GNU INFO SEARCH PRINT BOOK
 
Boot device configuration issues

Determining your system configuration for ATAPI (EIDE CD-ROM)

If you are uncertain of the hardware configuration of your system, but you know that the primary hard disk is attached to an IDE controller, the following information will allow you to determine the most likely configuration. This information is displayed at boot time.

Entries for the ATAPI CD-ROM will take a similar form, displaying the string type=IDE:

   %cd-rom   -   -  -  type=IDE  ctlr=pri  cfg=mst  drv=Srom->wd
Here, ctlr=pri indicates that the ATAPI CD-ROM drive is attached to the Primary IDE controller.
   %cd-rom   -   -  -  type=IDE  ctlr=sec  cfg=mst  drv=Srom->wd
Here, ctlr=sec indicates that the ATAPI CD-ROM drive is attached to the Secondary IDE controller.

If you are in doubt as to your system configuration, check the documentation that was supplied with your hardware.


Next topic: ATAPI (EIDE CD-ROM) limitations
Previous topic: Using the ATAPI (EIDE CD-ROM) driver

© 2003 Caldera International, Inc. All rights reserved.
SCO OpenServer Release 5.0.7 -- 11 February 2003