DOC HOME SITE MAP MAN PAGES GNU INFO SEARCH PRINT BOOK
 
Adding printers

Adding printers

To set up a printer on your system, see ``Installing parallel and serial printers''.

Once you have installed the printer, configure it for the print service as described in ``Adding local printers''. If required, you can customize the printer spooling software as described in ``Customizing printer configuration''.

Information about the network printing capabilities of SCO OpenServer is presented in ``Distributed printing''. If you are installing a Hewlett-Packard network printer, refer to the network installation instructions that accompany the printer. To configure the networking and printer spooling software, see ``Configuring Hewlett-Packard network printers and print services''.

For information on remote printing, see ``Connecting to remote UNIX system printers'' and ``Printing remotely over TCP/IP''. For information on dialup printers see ``Configuring an UUCP dialup printer''.

See also ``Troubleshooting printers''.


Next topic: Installing parallel and serial printers

© 2003 Caldera International, Inc. All rights reserved.
SCO OpenServer Release 5.0.7 -- 11 February 2003