Adding the SLIP protocol stack
You must add the SLIP protocol stack before
configuring any SLIP links. To do so:
Log in as root
on the machine on which you want to configure
the SLIP stack,
and run the Network Configuration Manager.
Select Add new WAN connection from the Hardware menu.
Select SCO TCP/IP SLIP driver from the list of
WAN connection types.
Select SCO TCP/IP from the list
of networking protocols that can be used with SLIP,
and click on Add.
To add a link endpoint, choose a link configuration type and
follow the instructions in
``Adding a SLIP link'',
beginning with step 5.
To defer configuring links, click on Cancel.
A message appears indicating that the SLIP driver
has been successfully configured.
Select Exit from the Hardware menu.
Select Yes when prompted to relink the kernel,
and enter y at the two prompts that appear shortly after.
Shut the system down and reboot it by using the
System Shutdown Manager
as described in the
SCO OpenServer Handbook.
Remember to select Reboot after shutdown when using the manager.
Adding a SLIP link
© 2003 Caldera International, Inc. All rights reserved.
SCO OpenServer Release 5.0.7 -- 11 February 2003