DOC HOME SITE MAP MAN PAGES GNU INFO SEARCH PRINT BOOK
 
(TLI/XTI)

t_rcvudata(NET)


t_rcvudata -- receive a data unit

Syntax

TLI syntax

cc . . . -lnsl

#include <sys/tiuser.h>

int t_rcvudata (fd, unitdata, flags) int fd; struct t_unitdata *unitdata; int *flags;

XTI syntax

cc . . . -lxti

#include <xti.h>

int t_rcvudata (fd, unitdata, flags) int fd; struct t_unitdata *unitdata; int *flags;

Description

The t_rcvudata function is used in connectionless mode to receive a data unit from another transport user. fd identifies the local transport endpoint through which data is received, unitdata holds information associated with the received data unit, and flags is set on return to indicate that the complete data unit was not received. unitdata points to a t_unitdata structure containing the following members:
       struct netbuf addr;   /* caller's address             */
       struct netbuf opt;    /* options                      */ 
       struct netbuf udata;  /* user data returned by caller */
The maxlen field of addr, opt, and udata must be set before issuing this function to indicate the maximum size of the buffer for each.

On return from this call, addr specifies the protocol address of the sending user, opt identifies protocol-specific options that were associated with this data unit, and udata specifies the user data that was received.

By default, t_rcvudata operates in synchronous mode and waits for a data unit to arrive if none is currently available. However, if O_NONBLOCK is set (via t_open or fcntl), t_rcvudata executes in asynchronous mode and fails if no data units are available.

If the buffer defined in the udata field of unitdata is not large enough to hold the current data unit, the buffer is filled and T_MORE is set in flags on return to indicate that another t_rcvudata should be issued to retrieve the rest of the data unit. Subsequent t_rcvudata call(s) return zero for the length of the address and options until the full data unit has been received.

Return values

t_rcvudata returns 0 on successful completion and -1 on failure, and t_errno is set to indicate the error.

Diagnostics

On failure, t_errno may be set to one of the following:

[TBADF]
The specified file descriptor does not refer to a transport endpoint.

[TBUFOVFLW]
The number of bytes allocated for the incoming protocol address or options is not sufficient to store the information. The unit data information to be returned in unitdata is discarded.

[TLOOK]
An asynchronous event has occurred on this transport endpoint and requires immediate attention.

[TNODATA]
O_NONBLOCK was set, but no data units are currently available from the transport provider.

[TNOTSUPPORT]
The T_CLTS service type is not supported by the underlying transport provider.

[TOUTSTATE]
The state should have been T_IDLE when this routine was called; XTI only.

[TSYSERR]
A system error occurred during execution of this function. One possibility, indicated by errno set to EPROTO, is a protocol error.

See also

Intro(NET), netbuf(FP), t_rcvuderr(NET), t_sndudata(NET)

Standards conformance

t_rcvudata is conformant with:

AT&T SVID Issue 3 ;
X/Open CAE Specification, Networking Services, Issue 4, 1994. ;
and Intel386 Binary Compatibility Specification, Edition 2 (iBCSe2) .


© 2003 Caldera International, Inc. All rights reserved.
SCO OpenServer Release 5.0.7 -- 11 February 2003